USB 烧录 只能烧录成功linux3.0.5

jack

     每次运行MfgTool之后 load 完下载文件之后  ，就自动断开的目标班与PC 的链接

软件01

如果可以的话，换个电脑的USB接口，还有就是有没串口打印信息，可以发个附件给我看看

jack

软件01 发表于 2016-12-22 09:55
如果可以的话，换个电脑的USB接口，还有就是有没串口打印信息，可以发个附件给我看看 ...

烧写Linux 301452  
name = Linux-3.14.52
ek_name = myimx6ek200
ek_spec = 6s-1g
rootfs_l31452_file = distro-core-image-base.tar.bz2

串口打印信息

U-Boot 2015.04-svn54 (Aug 04 2016 - 15:31:13)

CPU:   Freescale i.MX6SOLO rev1.3 at 792 MHz
CPU:   Temperature 52 C
Reset cause: POR
Board: MYZR i.MX6 Evaluation Kit
Model: MY-IMX6-EK200-6S-1G
I2C:   ready
DRAM:  1 GiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
SF: Detected SST25VF016B with page size 256 Bytes, erase size 4 KiB, total 2 MiB
*** Warning - bad CRC, using default environment

No panel detected: default to Hannstar-XGA
Display: Hannstar-XGA (1024x600)
In:    serial
Out:   serial
Err:   serial
Net:   FEC [PRIME]
Boot from USB for mfgtools
Use default environment for                              mfgtools
Run bootcmd_mfg: run mfgtool_args; bootz ${loadaddr} ${initrd_addr} ${fdt_addr};
Hit any key to stop autoboot:  0
Kernel image @ 0x12000000 [ 0x000000 - 0x51e8d8 ]
## Loading init Ramdisk from Legacy Image at 12c00000 ...
   Image Name:   fsl-image-mfgtool-initramfs-imx6
   Image Type:   ARM Linux RAMDisk Image (gzip compressed)
   Data Size:    7508220 Bytes = 7.2 MiB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
## Flattened Device Tree blob at 18000000
   Booting using the fdt blob at 0x18000000
   Using Device Tree in place at 18000000, end 1800cbd0

Starting kernel ...