卡在了这里
myts_ft5x0x 0-0038: touchscreen probe failed
read sensor who am i (0xfffffffa)error !
fxls8471: probe of 0-001e failed with error -22
rtc-isl1208 0-006f: rtc core: registered rtc-isl1208 as rtc0
snvs_rtc 20cc000.snvs:snvs-rtc-lp: rtc core: registered 20cc000.snvs:snvs-r as rtc1
i2c /dev entries driver
IR NEC protocol handler initialized
IR RC5(x/sz) protocol handler initialized
IR RC6 protocol handler initialized
IR JVC protocol handler initialized
IR Sony protocol handler initialized
IR SANYO protocol handler initialized
IR Sharp protocol handler initialized
IR MCE Keyboard/mouse protocol handler initialized
IR XMP protocol handler initialized
pxp-v4l2 pxp_v4l2: initialized
0-000e supply vdd not found, using dummy regulator
0-000e supply vddio not found, using dummy regulator
mag3110 0-000e: check mag3110 chip ID
mag3110 0-000e: read chip ID 0xfffffffa is not equal to 0xc4!
mag3110: probe of 0-000e failed with error -22
记录了1+0 的读入
记录了1+0 的写出
1024字节(1.0 kB)已复制,0.0333685 秒,30.7 kB/秒
Disk /dev/sdc doesn't contain a valid partition table
DISK SIZE - 15931539456 bytes
Checking that no-one is using this disk right now ...
OK
磁盘 /dev/sdc:15193 个柱面,64 个磁头,32 个扇区/磁道
sfdisk: ERROR: sector 0 does not have an msdos signature
/dev/sdc: unrecognized partition table type
旧状况:
No partitions found
新状况:
Units = mebibytes of 1048576 bytes, blocks of 1024 bytes, counting from 0
设备 启动 开头 结束 MiB #块 Id 系统
/dev/sdc1 10 509 500 512000 c W95 FAT32 (LBA)
/dev/sdc2 0 - 0 0 0 空
/dev/sdc3 0 - 0 0 0 空
/dev/sdc4 0 - 0 0 0 空
Warning: no primary partition is marked bootable (active)
This does not matter for LILO, but the DOS MBR will not boot this disk.
成功写入了新分区表
正在重新读取分区表...;
If you created or changed a DOS partition, /dev/foo7, say, then use dd(1)
to zero the first 512 bytes: dd if=/dev/zero of=/dev/foo7 bs=512 count=1
(See fdisk(8).)
################################################################################
mkfs.fat 3.0.26 (2014-03-07)
mkfs.fat: warning - lowercase labels might not work properly with DOS or Windows